Canon PIXMA MX922 Setup Manual

Also see for MX920 series: Online manual Online manual Online manual Setup Online manual

Contents

The device may not be able to connect to the network in the following cases:If the DHCP function of the access point is inactive, enable the DHCP function or specify the IP address (IPv4 only)of the printer and configure wireless connection settings again. In addition, make sure that the selected WEP keynumber and entered WEP key are correct.For details on how to check or change the settings of the access point, refer to the manual supplied with the accesspoint or contact its manufacturer.To specify the IP address of the printer, follow the procedure below.1. Press the MENU button.2. Select Setup in the next screen, then press the OK button.3. Select Device settings, then press the OK button.4. Select LAN settings, then press the OK button.5. Select Other settings, then press the OK button.6. Select TCP/IP settings, then press the OK button.7. Select IPv4, then press the OK button.8. Select Yes, then press the OK button.9. Select IP address, then press the OK button.10. Select Manual setup, then press the OK button.Follow the on-screen instructions to proceed with settings.When the setup is complete, press the MENU button.To perform Advanced setup again1. Press the MENU button (A).2. Use the buttons (B) to select WLAN setup, then press the OK button.

/ 30

Related manuals for Canon MX920 series