Canon PowerShot G10 Service Manual

Also see for PowerShot G10 - Digital Camera - Compact: Software guide Software guide User manual User guide Software user's guide

Contents

Canon PowerShot G10 Service Manual Manual pdf 39 page image

22. Troubleshooting2.1 When an Error Code is Displayed[Remedy]• Check for any abnormalities in the mounting of probable faulty parts or connector connections referring to thetable below.• Try replacing probable faulty parts referring to the below.[NOTE]• The error code is displayed on the LCD Monitor.• Adjustments must be performed after the part has been replaced. For details, see the “Adjustments” chapter.Error Code Name Occurrence Conditions Cause and Probable Faulty PartE01 AE TIME OUT AE processing does not end within thespecified time.MAIN PCB ASS’YE02 AF TIME OUT AF processing does not end within thespecified time.MAIN PCB ASS’YOPTICAL UNITThe focus lens is not driven. MAIN PCB ASS’YOPTICAL UNITE03 EF TIME OUT Auto Flash Control does not end within thespecified time.MAIN PCB ASS’YOPTICAL UNITE04 AWB TIME OUT AWB processing does not end within thespecified time.MAIN PCB ASS’YE09 JPEG DMA TIMEOUTJPEG processing does not end within thespecified time.MAIN PCB ASS’YE10 JPEG IC ERROR JPEG compression processing does not endwithin the specified time.MAIN PCB ASS’YE14 UNKNOWN When an error of unknown cause occurs. UNKNOWNE16 IMAGING TIMEOUTWhen communication between CPU andperipheral IC is not completed within thespecified time during recording using EVF orafter completion of recording.MAIN PCB ASS’YE23 MEMORY CARDNO SPACEWhen the Memory Card becomes full duringwriting of photographed images to MemoryCard, writing is repeatedly performed with theJPEG compression ratio successivelyincreased to reduce the size of the image fileuntil it can be successfully written to MemoryCard. This error occurs when writing of theJPEG image file fails after 10 times.MAIN PCB ASS’YE24 POWER ONERRORThe power of the imaging circuit on the MAINPCB ASS’Y is not detected.MAIN PCB ASS’YE26 CAPTURE TIMEOUTWriting of the photographed image to SDRAMdoes not end within the specified time.MAIN PCB ASS’YE27 MEMORY WRITETIME OVERData from the buffer was not written to thememory card within the specified time.MEMORY CARDE32 ISError When IS-CPU or DIGIC does not workcorrectly. (Breakdown of hardware(communication line))MAIN PCB ASS’YE41 USB Error Communication between DIGIC and USBcommunication IC failed.(Target: Models after DIGIC IV.)MAIN PCB ASS’YE52 QUICK REVIEWERRORReview of the photographed image failed. MAIN PCB ASS’Y