8. Camera Settings 1098. Camera SettingsSetting the Power Saving FunctionThis camera is equipped with a power savingfunction. Depending on the power saving setting(p. 69), the camera may power down or the LCDmonitor may go off automatically.z Auto Power Down[On]: zShooting modePowers down approximately 3 minutes after thelast time a camera control is accessed. The LCDmonitor automatically shuts off approximately1 minute* 1 after the last time a camera control isaccessed even if [Auto Power Down] is set to[Off]. Press any of the camera’s button to turn theLCD monitor back on.* 1 This time can be changed.zPlayback modePowers down approximately 5 minutes after thelast time a control is accessed on the camera.zPrinter Connection modePowers down approximately 5 minutes after thelast time a control is accessed on the camera.[Off]: The power saving function does not activate.z Display Off (Shooting Mode Only)The LCD monitor shuts off after a specified period of timeelapses and no camera control is accessed.The following time settings can be selected: 10 sec. /20 sec. /30 sec./1 min.* 2 /2 min./3 min.* 2 Default settingWhen the Auto Power Down FunctionActivatesTurn the power on again.Shooting mode: Close the lens cover, then open itagain.Playback/Printer Connection mode: Press the(Playback) button.When the Display Off Function ActivatesThe LCD monitor will be displayed if any of thecamera's buttons are pressed. Please note that the camera continues toconsume a minimal amount of power evenwhen the power saving function shuts it down. The power saving function is disabled while aslide show plays on the camera or during acomputer connection (p. 104, 117).
