Using an Eye-Fi Card217Check the access point SSID used by the Eye-Fi card or the connectionstatus, as needed.z Press the n button, choose [Eye-FiSettings] on the 3 tab, and then press them button.z Choose [Connection info], and then press them button.X The connection information screen isdisplayed.Configure the setting as follows to disable Eye-Fi transfer by the card, ifnecessary.Choose [Disable] in [Eye-Fi trans.].z Press the n button, choose [Eye-FiSettings] on the 3 tab, and then press them button.z Choose [Eye-Fi trans.], and then choose[Disable].• Power saving (p. 36) on the camera is temporarily disabled during imagetransfer.• Choosing mode will interrupt the Eye-Fi connection. Although the Eye-Ficonnection will be restored after you choose another shooting mode or enterPlayback mode, the camera may transfer any movies made in mode again.Checking Connection InformationDisabling Eye-Fi Transfer• [Eye-Fi Settings] is not shown unless an Eye-Fi card is in the camerawith its write-protect tab in the unlocked position. For this reason, youcannot change settings for an inserted Eye-Fi card if the write-protecttab is in the locked position.COPY
