Canon RealIS SX80 Mark II User Manual
Also see for REALiS SX80 Mark II D: BrochureUser guideBrochureProduct guideBrochure & specs
                         | |
Contents
| 
5CHAPTER 1 • IntroductionConfiguring the Network Settings of the SoftwareC14When installation of this software is complete, run the software and configure the discoverysettings of the network for discovery.Starting the Software1.4.1Click the Windows [Start] menu and select [All Programs], followed by1 [Projector Monitoring Software] and [Projector Monitoring Software].Main screen of this software will display.Configuring the Discovery Settings1.4.2Configure the network range for discovering projectors. Methods vary depending on "SNMPV1/V2c/V3" and "LV Series". Configure each protocols respectively.For SNMP V1/V2c/V3■When using "SNMP V1" / "SNMP V2c" / "SNMP V3", you can specify a broadcast address orIP address range for discovery. Select a protocol type and configure the range for discovery.Configure SNMP V1/V2c/V3 with the following procedures. Configuration can be done withthe same procedures. SNMP V3 is used in this example.From [Discovery settings] of the [Option] menu, select a name of protocol1 ([SNMP V1] / [SNMP V2c] / [SNMP V3]) to configure.[Discovery settings] dialog will display.Place a checkmark in [Enable (Protocol Name)].2Remove a checkmark if protocol is not used for discovery.COPY |
Related manuals for Canon REALiS SX80 Mark II D
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine