Starting the Memory Card Startup Utility 64Using the Memory Card Startup Utility (Windows)Starting the Memory Card Startup UtilityUse and set the Memory Card Startup Utility to change the settings when you insert amemory card or to change the mode of the card slot.Normally, the Memory Card Startup Utility starts automatically when you insert a memorycard. To start the Memory Card Startup Utility manually, follow the procedure describedbelow.Note ä • Always use the Memory Card Startup Utility to eject a memory card. Ifyou eject a memory card while the indicator lamp is on or blinking, thememory card may not operate properly.• When you select Change the drive’s read/write attribute. and set theRead/Write mode, note the following points:- Change the write protection (switch or seal to prevent accidentalerasing) of the memory card to write-enabled mode before inserting thememory card. If you insert a write-protected card, the computer may notoperate normally.- If you change the contents of a memory card, you must format thememory card with a digital camera, otherwise you may not be able totake photographs. This printer supports only the format used by thedigital camera. Since this printer does not support the unique format ofthe computer, format it with the digital camera.- If you change or manipulate the contents of a memory card from acomputer, be sure to print the contents from the computer. If you printthe contents from the operation panel, the information may not printproperly.
