Canon TR8660 Online Manual

Also see for PIXMA HOME OFFICE TR8660: Getting started

Print settings• Prevent paper abrasionUse this setting only if the print surface becomes smudged.Important• Be sure to set this back to OFF after printing since it may result in lower printing speed or lowerprint quality.• Amount of extensionSelects the amount of image that extends off the paper when printing in borderless (full).When performing Borderless Printing, slight cropping may occur at the edges since the printed image isenlarged to fill the whole page. You can change the width to be cropped from the borders of the originalimage as needed.Important• Settings will become ineffective in the following situations:Printing from a PictBridge (Wi-Fi) supporting device.Printing from a standard form.Note• When performing settings from application software or the printer driver, these settings will beprioritized.• If printouts contain margins even though you are printing in Borderless, specifying Extendedamount: Large for this setting may help solve the problem.• Auto photo fix settingsWhen ON is selected, you can select whether to print photos using the Exif information recorded in theimage files in the following cases.◦ Auto photo fix is selected for Photo fix when printing from a memory card.◦ The print setting on the PictBridge (Wi-Fi) compliant device is set to Default* or On when printingwith a PictBridge (Wi-Fi) compliant device.* When Default is selected for the print setting on the PictBridge (Wi-Fi) compliant device, selectAuto photo fix for Photo fix in PictBridge settings.• Adjust horizontal print positionAdjusts the print position when the left/right margins are not aligned.You can adjust the left/right margins in increments of 0.004 in. (0.1 mm) between -0.12 in. (-3 mm) and+0.12 in. (+3 mm) centered on the horizontal center of the paper.Important• For Letter-sized or Legal-sized paper, you can adjust the left/right margins between -0.06 in. (-1.5mm) and +0.06 in. (+1.5 mm) even if you specify the value over 0.06 in. (1.5 mm).190