Canon VIXIA HV40 Instruction Manual

Contents

Canon VIXIA HV40 Instruction Manual Manual pdf 93 page image

Trouble? 93Additional InformationList of MessagesSome error messages will disappear after being displayed for about 4 seconds.Message Explanation/SolutionSET THE TIME ZONE,DATE AND TIMEYou have not set the time zone, date and time. This messageappears each time you turn the power on until you set the timezone, date and time.26CHANGE THE BATTERYPACKBattery pack is exhausted. Replace or charge the battery pack. 20THE TAPE IS SET FORERASURE PREVENTIONCassette is protected. Replace the cassette or change the positionof the protect switch.97REMOVE THE CASSETTE Camcorder stopped operating to protect the tape. Remove thecassette and reinsert it.22CHECK THE HDV/DVINPUT(Appears only if a DV cable isconnected)The DV cable is not correctly connected to the HDV/DV terminal, orthe connected digital device is turned off.71The video input signal is in a different television system (PAL orSECAM).–CONDENSATION HASBEEN DETECTEDCondensation has been detected in the camcorder. 99CONDENSATION HASBEEN DETECTEDREMOVE THE CASSETTECondensation has been detected in the camcorder. Remove thecassette.99TAPE END Tape reached the end. Rewind the tape or replace the cassette. –INCORRECT TAPESPECIFICATIONYou attempted to play back a tape recorded in a different televisionsystem (PAL or SECAM) or in a recording standard not supportedby this camcorder.–INPUT SIGNAL NOTSUPPORTEDThe digital device connected with the DV cable is incompatible withthe camcorder.–PLAYBACK STD LOCKEDINCOMPATIBLE VIDEOINPUTCurrent camcorder settings do not match the HDV/DV standard ofthe video input signal. Change the [PLAYBACK STD] setting tomatch the video input signal.42PLAYBACK STD LOCKEDPLAYBACK ISRESTRICTEDCurrent camcorder settings do not match the HDV/DV standard ofthe recording you tried to play back. Change the [PLAYBACK STD]to match the recording standard of the tape.42HEADS DIRTY, USECLEANING CASSETTEVideo heads are dirty. Clean the video heads. 99NO CARD There is no memory card in the camcorder. 22NO IMAGES No images are recorded on the memory card. –CARD ERROR A memory card error occurred. The camcorder cannot record ordisplay the image.The error may be temporary. If the message disappears after 4seconds and “ ” flashes red, turn the camcorder off, remove thecard and reinsert the card. If “ ” changes to green or yellow, youcan continue recording/playback.–CARD FULL Memory card is full. Erase some images to free some space orreplace the memory card.69COPY