Canon WFT-E1 Network Setup Manual

Also see for WFT-E1: Instruction manual

Contents

Canon WFT-E1 Network Setup Manual Manual pdf 19 page image

19W2 Infrastructure ModeThis section explains the minimal setup required to transfer images using a wireless LANaccess point with infrastructure mode. For detailed installation and setup procedures for awireless LAN access point, please read the instruction manual for the wireless LANaccess point or contact the manufacturer of the wireless LAN access point.Terms used in this section may differ depending on the manufacturer of the wireless LANaccess point.The high-speed transfer mode developed by the manufacturer may destabilizecommunication, so it is recommended not to use it.Operating mode, wireless mode, 802.11 mode, and other modes fall under this category.Select “802.11b”, “802.11g”, or “Automatic.”It is also known as the “ESSID.”Enter a series of alphanumeric characters (up to 36 characters).If a string is already entered, you do not need to change it.Enter the same SSID in the WFT-E1.Encryption and other items fall under this category.Set up “WEP” as the minimum security.Enter the encryption key set for WEP in the WFT-E1.If authentication can be selected, set it to “Open.”When using WPA-PSK authentication, use the TKIP encryption method. The WFT-E1does not accommodate the AES encryption method.Setting Up the Wireless LAN Access PointSelecting a Wireless LAN StandardSetting the SSIDSetting SecurityCOPY