Canon iR2230 Printer Manual

Also see for iR2230: Guide Manual Easy operation guide Service bulletin

Settings Menu2-102Printer Settings Menu■ Margin-50.0 to +50.0 mm (in increments of 0.5 mm); 0.0* mmThis setting sets the page margin in millimeters. The settings can be set between -50.0 mm(-1.90 inch) and +50.0 mm (+1.90 inch) in increments of 0.5 mm (0.01 inch).Use [ ] to increase the width of the inside margin.Use [ ] to increase the width of the outside margin.You can specify the edge along which the margin will be created in the Binding Location setting(previous setting). To create a margin along one of the edges of the paper, use this setting incombination with the Binding Location setting.IMPORTANTIf this setting moves the image outside the printable area, part of the image may be cut off.NOTE• If this setting is used in combination with the Offset X/Offset Y setting, the values of the twosettings are added together.• Pressing [ ] increases the setting value by 0.5 mm (0.01 inch) each time the key is pressed.Pressing [ ] decreases the value by 0.5 mm (0.01 inch) each time. Holding down either [ ]or [ ] continuously speeds up the value alteration.[ + ] [ - ][0 mm]Left MarginCenter Center CenterRight Margin