Chapter 1313-16by 0.1 mm.3) Record the new setting on the service label.- ADJ-REFE- margin adjustment (2nd side; large-size; A4/LTRor longer in feed direction)1) Make a double-sided copy (large-size) using thecassette you have adjusted for the 1st side as thesource of power, and check to make sure that the frontmargin is 2.5 +/-2.0 mm.F-13-322) If the value is not as indicated, change theadjustment value for 2nd side horizontal registrationfor large-size.- COPIER>ADJUST>FEED-ADJ>ADJ-RE-LAn increase of '1' will decrease the margin on the frontby 0.1 mm.3) Record the new setting on the service label.- ADJ-RE-L13.6.2 Adjusting theHorizontal RegistrationWhen Replacing theDuplex Unit 0007-4924iR2270 / iR2870 / iR3570 / iR4570 / iR35301) Make double-sided small- and large-size copies,and check to make sure that the front margin is 2.5+/-2.0 mm. A sheet is large-size if its length in feeddirection is longer than A4/LTR.F-13-332) If the value is not as indicated, change theadjustment value of the 2nd side horizontalregistration for small-/large-size.- COPIER>ADJUST>FEED-ADJ>ADJ-REFE(small-size)- COPIER>ADJUST>FEED-ADJ>ADJ-RE-L(large-size)An increases of '1' will decrease the margin at the frontby 0.1 mm.3) Record the new setting on the service label.- ADJ-REFE- ADJ-RE-L13.6.3 Adjusting theManual Feed PickupHorizontal Registration 0007-4925iR2270 / iR2870 / iR3570 / iR4570 / iR3530- 1st Side (mechanical)1) Place paper in the manual feed tray.For instructions on how to place paper, see the labelattached to the manual feeder assembly.2) Make a copy using the manual feeder as the sourceof paper, and check to make sure that the front marginis 2.5 +/-1.5 mm.0246810(-) (+)2.5±2.0mm0246810(-) (+)2.5±2.0mm
