Canon imageFORMULA R10 Installation Manual

Also see for ImageFormula R10: User manual Setup guide

Check the included itemsSetup GuideThere is no need to install any softwareor scanner driver.6T3-0114-01 XXXXXXXX © CANON ELECTRONICS INC. 2020 PRINTED IN JAPANDetailed ExplanationsFor detailed explanations on the scanner and CaptureOnTouchLite, refer to the user manual.https://software.canon-elec.co.jp/ims/r10/The user manual can also be displayed by double-clicking the[manual] icon on the original pop-up screen. See 3 of “How toScan”.HelpTechnical supportUSABy internet: www.usa.canon.com/supportBy phone: 1-800-423-2366CanadaBy internet: www.canon.ca/supportBy phone: 1-800-OK-CANON (652-2666)When the Software Update NoticeScreen AppearsClick the [Yes] button.ClickThe Web browser appears and downloading of theupdate file begins.Follow the instructions on the screen toinstall the update.Tips● When scanning a cardTurn the card face up, and insert the card straight intothe card slot.12Open the built in software(CaptureOnTouch Lite).• A pop-up screen will be displayed with the softwareicon.WindowsClickOS XClick• Pressing the scanner start button does not startCaptureOnTouch Lite.Raise the document guides and feedextension plates.Load the document. Turn the document upside down with the backside facing you, and load it into the feed tray.345How to ScanConnect the scanner and computer.Open the feed tray to turn on thescanner.1USB cable2Press the release leverwhile raising the feed trayStart button light up blueCheck the included itemsSetup Guide Align the document guides with both edges ofthe loaded document.• Press the document beneaththe tabs of the document guides.Select the document type and scannedimage storage location.• Clicking allows you to change the scan type andselect a location to save your document.• Clicking [New Document] allows you to add newsettings.• Clicking [New output] allows you to add new storagelocations.Click the [SCAN] button.Click• When the software is open, you can also startscanning with pressing the start button on thescanner.After confirming the scanned image,click the [Finish] button.ClickTab678If CaptureOnTouch Lite does not start, take thefollowing measures.• Disconnect and reconnect the USB cable.• If the scanner and computer are connected via aUSB hub, remove the USB hub and connect themdirectly with a USB cable.• Check whether access to USB devices is prohibitedby security software, and allow access if it isprohibited.• In Windows, AutoPlay for USB memory devicesmay be off. In that case, open Explorer and run the[CaptureOnTouch Lite] icon in [Devices and drives].There is no need to install any softwareor scanner driver.Double-click the [CaptureOnTouch LiteLauncher] icon.Click [Open storage folder].Click9