HP-GL/2 jobs are printed in monochrome (or color)Cause Corrective ActionThe Color Mode setting inthe Control Panel menu is in-correct.Check the Color Mode setting in the Control Panel menu.(See "Menu Settings.") →P.716However, for optimal Printhead performance, the printer consumes trace amounts ofcolor ink even when Monochrome is selected as Color Mode.Printed colors of lines are inaccurate during HP-GL/2 printingCause Corrective ActionAdjustFaintLines is On in theControl Panel menu.Setting AdjustFaintLines to Off in the Control Panel menu may help produce theexpected results. However, lines in some colors may appear broken.HP-GL/2 jobs are printed 6 mm larger than specifiedCause Corrective ActionThe page size of the HP-GL/2 print job, as created in thesource application, is incorrect.In the Control Panel menu, set PageSizeProcess1 to On.(See "Menu Settings.") →P.716HP-GL/2 jobs are printed at maximum size, even if a standard size is specifiedCause Corrective ActionThe page size of the HP-GL/2 print job, ascreated in the source application, is incor-rect.In the Control Panel menu, set PageSizeProcess2 or Conserve Paperto On.The layout will be changed to the optimal layout.(See "Menu Settings.") →P.716HP-GL/2 printing takes a long timeCause Corrective ActionLarge print jobs with a lot of data take longer to print. Please wait a while until printing is finished.A job was printed when Input Resolution in the Con-trol Panel menu was set to 600dpi.In the Control Panel menu, set Input Resolution to 300dpiand print again.(See "Menu Settings.") →P.716The printer stops when printing a HP-GL/2 job (the carriage stops moving)Cause Corrective ActionThe printer is analyzing the print job. Please wait a while until printing is finished.Troubleshooting > HP-GL/2 problems >HP-GL/2 jobs are printed in monochrome (or color) iPF75512852
