Canon imageRUNNER 2545i Copying Manual

Also see for imageRUNNER 2520: Printer guide User guide Client guide User guide Service manual

Contents

Selecting the Paper Size 2-7Basic Copying Features2● If you want to select a nonstandard paper size:IMPORTANT• Make sure that the paper size setting is correct. If the paper size loaded on thestack bypass and the paper size setting do not match, a paper jam may occur.• The following modes are not available for nonstandard size paper: RotateCollate, Rotate Group, Offset Collate, Offset Group, Staple, 1 to 2-Sided, 2 to2-Sided, Book to 2-Sided, 2-Page Separation, Image Combination, or ID CardCopy.NOTE• If you make a mistake when entering values, press [C] (Clear) ➞ enter thecorrect values.• When entering values in millimeters, you can also use - (numeric keys)and (Clear) on the control panel.• To enter values in inches, the Inch Entry setting must be enabled. (See Chapter3, “Configuring the Machine’s Basic Settings,” in the Reference Guide.)• When entering the length in inches, an underbar (_) must be entered betweeninteger and fraction.• You can store up to two sets of frequently used sizes. Press [Store/Edit] ➞ [Size1] or [Size 2] ➞ enter the value for and ➞ press [OK].• To recall the stored size, press [Size 1] or [Size 2] ➞ press [OK] and proceed tothe next step to specify the paper type.❑ Press [Irreg. Size].❑ Press [X] ➞ enter the length along thehorizontal axis of the paper using thenumeric keys.The horizontal length can be setbetween 148 mm and 432 mm.❑ Press [Y] ➞ enter the length along thevertical axis of the paper using thenumeric keys.The vertical length can be set between99 mm and 297 mm.❑ Press [OK].