Cansec VIA Installation Manual
Also see for VIA: Installation manual
                    | |
Contents
| 
Via Wireless LockInstallation Manual July 2018 • Rev. 1.3Page of1620READER STATUS LEDSThe Via Lock reader is equipped with three status LEDs. These LEDs make it very simple to com-mission the systems and monitor its ongoing operation. When a card is presented:1. Connect the following cables to the Control Unit (see Figure 4 for location).• LED Cable and Reader Cable from the Via Reader• Lock Motor Cable and the REX Cable from the Lockset• Door Contact Cable from the Door Contact (optional)2. Snap 4 AA batteries in the battery holder to power up the Control Unit (see Figure 4).3. Press the Reset button.• The RED LED will flash ONCE to confirm that the card was read.• The GREEN LED will flash ONCE to confirm that the Wieganddata has been sent to the Via Hub.• The YELLOW LED may flash ONCE to indicate that the transac-tion was successfully received by the Hub but the signal level is weak.This could be caused by the introduction of a physical obstructionwhich was not present the the Via Lock was initially installed.• The YELLOW LED may flash TWICE if the battery level is low.• The YELLOW LED may flash THREE times if the signal level isweak AND the battery level is low.• If access is granted, the Lock will beep ONCE and the GREEN LEDwill come on momentarily.• If access is denied, the RED LED will flash TWICE.• If the battery level is so low that the card data cannot be sent to theHub, the RED and YELLOW LEDs will come on momentarily whena card is presented.READER STATUS LEDS(RED, YELLOW, GREEN)POWER ON CONTROL UNITFigure 6:Reader Status LEDsDIP SWITCH “E” - PROGRAM MODEThis is the large RED switch and is used to put the board into PROGRAM or RUN mode. When-ever ANY of the programming DIP switches are changed, the PROGRAM DIP switch must be setto PROGRAM (UP/ON) and the reset pushbutton to its immediate right must be momentarilypressed. This loads the defined program values into memory and verifies them. When the PRO-GRAM function is completed, the Via control unit will beep and will continue to beep until theDIP switch is returned to the RUN position (DOWN/OFF) and the reset switch is pressed again.The Via Lock will then attempt to connect to it’s assigned Via Hub. You can verify that it is con-nected by operating the inside lever. If the event is detected and successfully transmitted to theHub, the blue Connection Status LED in the top left corner of the controller board will blink once. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine