Carrier 19XL Installation Instructions Manual

Also see for 19XL series: Start-up, operation and maintenance instructions Start-up, operation and maintenance instructions Advance product data Installation instructions Installation instructions

Contents

Carrier 19XL Installation Instructions Manual Manual pdf 11 page image

INSTALL SPRING ISOLATION — Spring isolation maybe purchased as an accessory from Carrier for field instal-lation. It may also be field supplied and installed. Spring iso-lators may be placed directly under chiller support plates orlocated under chiller soleplates. See Fig. 13. Consult job datafor specific arrangement. Low profile spring isolation as-semblies can be field supplied to keep the chiller at a con-venient working height (Fig. 14).Obtain specific details on spring mounting and chiller weightdistribution from job data. Also, check job data for methodsto support and isolate pipes that are attached to spring iso-lated chillers.LEGENDH.R.S. — Hot Rolled SteelUNC — Unified Coarse (Screw Thread Designation)NOTES:1. Dimensions in ( ) are in millimeters.2. Accessory (Carrier supplied, field installed) soleplate packageincludes 4 soleplates, 16 jacking screws and leveling pads. Re-quires accessory spring isolators package.3. Jacking screws to be removed after grout has set.4. Thickness of grout will vary, depending on the amount necessaryto level chiller. Use only pre-mixed non-shrinking grout, CeilcoteHT-648 or Master Builders 636, 08-1 1⁄ 29 (38.1) to 08-2 1⁄ 49 (57) thick.Fig. 12 — Accessory IsolationNOTE: The accessory spring isolators are supplied by Carrier for in-stallation in the field.Fig. 13 — 19XL Accessory Spring Isolation(Shown with Accessory Soleplates)NOTE: A field supplied and installed, low-profile isolation is sug-gested to keep operation height low.Fig. 14 — Typical 19XL Low ProfileIsolation Assembly11