Carrier 38MGQ Installation Instructions Manual

Also see for 38MGQ Series: Service manual Installation instructions

Carrier 38MGQ Installation Instructions Manual Manual pdf 34 page image

34INSTALLING THE INDOOR UNIT1. PreparationS Open the front panel, remove the 4 screws and dismountthe front grille while pulling it forward.Fig. 66 --- Remove the screwsFig. 67 --- Remove the screwsS Follow the arrows to disengage the clasps on the front caseto remove it.S Follow the procedure below when removing the slitportions.For MoldingsS Remove the pillars. Remove the slit portions on the bottomframe using nippers.3)Sidecasings2)Upper casing3)SidecasingsRemove the pillarRemove screwsFig. 68 --- Remove the screwsFor Side PipingS Remove the pillars.(1.) Remove the screws.(2.) Remove the upper casing (2 tabs).(3.) Remove the left and right casings (2 tabs on eachside).(4.) Remove the slit portions on the bottom frame andcasings using nippers.(5.) Return by following the steps in reverse order(3>2>1).CasingRemove the pillarFig. 69 --- Remove the pillarCasingRemove the pillarBottom frameFig. 70 --- Remove the pillar2. InstallationS Secure using 6 screws for floor installations. Do notforget to secure to the rear wall.S For wall installations, secure the mounting plate using 5screws and the indoor unit using 4 screws.