9Table 1—Periodic MaintenanceINDOOR UNIT EVERY 3 MONTHS EVERY 6 MONTHS EVERY YEARClean Air Filter*Change Remote Control BatteriesSSSOUTDOOR UNIT EVERY 3 MONTHS EVERY 6 MONTHS EVERY YEARClean Outdoor Coil from OutsideClean Outdoor Coil from Inside†Blow Air Over Electric Parts†Check Electric Connection Tightening†Clean Fan Wheel†Check Fan Tightening†Clean Drain Pans†SSSSSSS* Increase frequency in dusty zones.{ Maintenance to be carried out by qualified service personnel. Refer to the Installation ManualTable 2—TroubleshootingPROBLEM POSSIBLE CAUSE SOLUTIONIndoor unit emits a bad odor onstart- up Air filter dirty Output air still has odor after cleaning filter. Clean the air filter Contact your service representative.You hear water flowing noisewhen the unit is running This is normal and is the refrigerant flowingthrough the system. No maintenance requiredIndoor unit produces a mistwhen the air conditioner isrunning This is normal cooling and is caused by highhumidity and temperature in the room. No maintenance required. Mist should stop asroom is cooled down and the humidity is removed.Wireless remote control doesnot work Batteries are dead. Unit needs to be reset. See battery replacement section in this manualand replace batteries. Turn off power to indoor unit. Remove plug fromwall and then reinsert plug. Restart unit.Water leaks into room fromIndoor unit Condensing water has overflowed Check indoor condensing drain or call yourrepresentative.Unit/System Does Not Work To protect the unit upon an immediate restartafter a stop, the system controller delaysthe unit for 3 minutes before allowing the unitto start back up. The circuit breaker has tripped or a fusehas blown. Power failure. Error codes displayed Voltage is too low. After turning unit off, wait at least 3 minutes beforetrying to restart. Reset the circuit breaker or replace the fuse withthe specified replacement fuse. Restart operation when the power is restored. Call your service representative. Call your service representative.Cooling is Not WorkingProperly The filter is blocked with dust. Temperature is not set properly. A window or door is open. The outdoor unit is obstructed. The fan speed is too low. The operation mode is in Fan instead ofCool. Clean the air filter. Check the temperature and reset if necessary. Close the window or door. Remove the obstruction. Change the fan speed selection. Change the operating mode to Cool or reset theunit.Heating is Not WorkingProperly The filter is blocked with dust. Temperature is set too low. A window or door is open. The outdoor unit is obstructed. Clean the air filter. Check the temperature and reset if necessary. Close the window or door. Remove the obstruction.Unit Stops During Operation The Off timer is not operating correctly. Error codes displayed Restart the operating mode. Call your service representative.