8INSTALLATION GUIDEIdeal installation locations include:Indoor UnitS A location where there are no obstacles near inlet and outlet area.S A location which can bear the weight of indoor unit.S Do not install indoor units near a direct source of heat such asdirect sunlight or a heating appliance.S A location which provides appropriate clearances as outlined inFig. 6. Be sure to leave enough distance to allow access forroutine maintenance. The installation site should be 66 in (1676mm) or more above the floor.S Select a place away from potential electronic interference.S Select a place where the filter can be easily removed.Outdoor UnitS A location which is convenient to installation and not exposed tostrong wind.S A location which can bear the weight of outdoor unit and wherethe outdoor unit can be mounted in a level position.S A location which provides appropriate clearances as outlined inFig. 6.S Do not install the indoor or outdoor units in a location withspecial environmental conditions.S Make sure the outdoor unit is installed in accordance with theinstallation instructions and is convenient for maintenance andrepair.S See the refrigerant piping table for the maximum heightdifference between indoor and outdoor units and the maximumlength of the connecting tubing.INDOOR UNIT INSTALLATIONINSTALL MOUNTING PLATE1. Carefully remove the mounting plate from the unit box.2. The mounting plate should be located horizontally and levelon the wall. All minimum spacings shown in Fig. 7through Fig. 10 should be maintained.3. If the wall is block, brick, concrete or similar material, drill.2” (5 mm) diameter holes and insert anchors for the ap-propriate mounting screws.4. Attach the mounting plate to the wall.30.3 (770)21.6 (548.5)50 (126.5)11.1 (283)10.2 (258.5)Unit: IN. (mm)A12534Fig. 7 --- 09 and 12K Mounting Plate Spacing1.6 (40)Φ55 Φ5534.1 (865)21.3 (540)6.9(175)5.9(150)1.6 (40)Unit: IN. (mm)A12535Fig. 8 --- 18k Mounting Plate SpacingΦ55Φ553.9(100)2.0 (50)39.7 (1008)27.0 (685)5.1 (130) 7.6 (193)12.6 (319)2.0 (50)4.9(124)Unit: IN. (mm)A12536Fig. 9 --- 24k Mounting Plate SpacingUnit: IN. (mm)29.4(746.8)13.7(348.0)10.0(254.0)A12584Fig. 10 --- 30/36k Mounting Plate SpacingWall WallMark middle Level(Rear piping hole)(Rear piping hole)See HoleSize TablesSee HoleSize Tables6 in.6 in.A12537Fig. 11 --- Mounting Plate Spacing