Fan StatusIf a Fan Status accessory was field installed, the unit must beconfigured for it by setting Configuration---_UNIT---_FN.SW tonormally open (1) or normally closed (2). Normally open (1) is thepreferred configuration.IMPORTANT: Fan Status input is not on the ternfinals markedFan Status.Filter StatusIf a Filter Status accessory was field installed, the unit must beconfigured for it by setting Configuration--_UNIT--_FL.SW tonormally open (1) or normally closed (2). Nom_ally open (1) is thepreferred configuration.DISPLAYMENUTIMECLOCKSCH.LSUBr-] r-]SUBMODEPER.1Table 4 -- Setting an Occupied Time Schedule - Weekdays Only for 7:30 to 22:30KEYPAD ITEM DISPLAYENTRYENTERENTER OCC.1ENTER 00.00ENTER 00.00• 07.00ENTER 07.00• 07.30ENTER 07.30ESCAPE OCC.1 07.30• UNC.1 00.00ENTER 00.00ENTER 00.00• 22.00ENTER 22.00• 22.30ENTER 22.30ESCAPE UNC.1 22.30• MON.1 NOENTER NO• YESENTER YESESCAPE MON.1 YES• TUE.1 NOENTER NO• YESENTER YESESCAPE TUE.1 YES• WED.1 NOENTER NO• YESENTER YESESCAPE WED.1 YES• THU.1 NOENTER NO• YESENTER YESESCAPE THU.1 YES• FRI.1 NOENTER NO• YESENTER YESESCAPE FRI.1 YESESCAPEESCAPEITEM EXPANSIONLocal Occupancy SchedulePeriod Occupied TimePeriod Occupied TimePeriod Unoccupied TimePeriod Unoccupied TimeMonday In PeriodMonday In PeriodTuesday In PeriodTuesday In PeriodWednesday In PeriodWednesday In PeriodThursday In PeriodThursday In PeriodFriday In PeriodFriday In PeriodCOMMENTScrolling stopsHours FlashSelect 7Change accepted, minutes flashSelect 30Change acceptedItem/Value/Units scrolls againScrolling stopsHours FlashSelect 22Change accepted, minutes flashSelect 30Change acceptedItem/Value/Units scrolls againScrolling stopsSelect YESChange acceptedItem/Value/Units scrolls againScrolling stopsSelect YESChange acceptedItem/Value/Units scrolls againScrolling stopsSelect YESChange acceptedItem/Value/Units scrolls againScrolling stopsSelect YESChange acceptedItem/Value/Units scrolls againScrolling stopsSelect YESChange acceptedItem/Value/Units scrolls again