GB - 6DehumidificationThe dehumidification only function should be used if youwant to remove moisture from the room air without loweringthe temperature.Place the unit in the space to be dehumidified (room, garage,cellar or storeroom).Plug the unit in.Open the air flow direction guide vane.Turn the mode selector to the dehumidification symbol.The dehumidification indicator lighton the control panel is illuminated.The air conditioner removes moisturefrom the air without lowering thetemperature.If the two red indicator lightson the control panel light up,this shows that the condensate watercollection tank is full.If this is the case the unit automaticallyswitches off.To empty the tank, switch the unit offby turning the mode selectorto the symbol.Remove the plug from the powersupply socket.Remove the outdoor unit if it is attachedto the indoor unit.Take out the full water tank on the rearside of the air conditioner and empty it.Then replace it correctly in its position.If the dehumidification modeis again required, plug in the unitand wait 5 minutes beforeagain turning the mode selectorto the dehumidification symbol.In certain applications a floor drain maybe provided and it may be easier to usethe drain tube to remove the condensa-te water directly. Proceed as follows:• pull out the 60 mm long condensatedrain tube and remove the plug.• Connect the drain tube to the floordrain using a rubber tube.After use remember to put the plug intothe drain tube and to replacethe tube in its position.1 23 4 56 7 810 119TURBOSILENTTURBOSILENT5 MIN.