5Using Air Conditioner To reduce the risk of fire, electric shock, or injury to persons, readthe IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.To begin operating the air conditioner, follow these steps:1. Plug in the air conditioner. (To prevent electrical hazards, do not use an extensioncord or an adapter plug.)2. Set the thermostat to the highest number (coldest or cooler setting).3. Set the selector control to the highest FAN or COOL setting (see below).4. Adjust the louvers for comfortable air flow (see Air Directional Louvers).5. Once the room has cooled, adjust the thermostat to the setting you find mostcomfortable.Review the “Air Conditioner Features” section for other settings.Air Conditioner Features The controls featured in this manual are representational of the many modelsavailable. Your model may offer slightly different features.Selector ControlThe selector control turns the unit on or off and allows a choice of either coolingroom air, circulating room air at the existing temperature, or heating room air.COOL/FANOperate COOL/FAN modes according to the following suggestions:• ON/OFF or OFF = Turns air conditioner on and off.• HIGH COOL = Maximum cooling speed. Begin operation of the air conditioner inthis mode.• LOW COOL = Fan runs slow for quiet operation when maximum cooling is notneeded.• HIGH FAN = Maximum air circulation without cooling.• LOW FAN = Slow air circulation without cooling.HEATThe HEAT selection provides quiet, efficient circulation of warm air. Turn the selectorto the HEAT setting and set the thermostat at WARMER setting. When the HEATsetting is selected, the thermostat maintains the temperature by automaticallyturning the heater on and off in response to room temperature. The fan runscontinuously to circulate air in the room.Once the room is warm, adjust the thermostat to a less warm position. This providesless heat, or cooler temperatures.A slight heat odor may come from the unit when first switching to HEAT after thecooling season is over. This odor, caused by fine dust particles on the heater, willdisappear quickly.Automatic ThermostatWhen a COOL or HEAT setting is selected, the thermostat controls the amount ofcooling or heating by automatically turning the cooling compressor or heater onand off in response to the room temperature.NOTE: If the air conditioner is turned off,wait 3 minutes before restarting. Thisallows pressure inside the compressor toequalize. Failure to follow theseinstructions may cause inefficientoperation.