Carrier AQUASNAP MPW015-045 Operation And Service Manual

Also see for AQUASNAP 30MPA: User manual Installation instructions Controls, start-up, operation, service, and troubleshooting

6Table 3 — Run Status Mode and Sub-Mode Directory (cont)*Press and simultaneously to obtain version number.Table 4 — Service Test Mode and Sub-Mode DirectoryTable 5 — Temperature Mode and Sub-Mode DirectorySUB-MODE KEYPADENTRY ITEM DISPLAY SUB-ITEM DISPLAY SUB-ITEM DISPLAY ITEMEXPANSION COMMENTVERS AUX CESR131333-xx-xx xx-xx is Version number*MBB CESR131279-xx-xx xx-xx is Version number*EMM CESR131174-xx-xx xx-xx is Version number*MARQ CESR131171-xx-xx xx-xx is Version number*NAVI CESR130227-xx-xx xx-xx is Version number*ENTERENTER ESCAPESUB-MODE KEYPADENTRY ITEM DISPLAY ITEMEXPANSION COMMENTTEST ON/OFF SERVICE TEST MODE To Enable Service Test Mode,move Enable/Off/RemoteContact switch to OFF. ChangeTEST to ON. Move switch toENABLE.OUTS OUTPUTS AND PUMPSCLR.P ON/OFF COOLER PUMP RELAYCND.P ON/OFF CONDENSER PUMPUL.TM 0 to 15 COMP A1 UNLOAD TIMECC.H ON/OFF CRANKCASE HEATERCW.VO ON/OFF CONDENSER VALVE OPENCW.VC ON/OFF CONDENSER VALVE CLOSELL.SV ON/OFF LIQUID LINE SOLENOIDRMT.A ON/OFF REMOTE ALARM RELAYCMPA CIRCUIT A COMPRESSOR TESTCC.A1 ON/OFF COMPRESSOR A1 RELAYUL.TM 0 to 15 COMP A1 UNLOAD TIMECC.A2 ON/OFF COMPRESSOR A2 RELAYCC.A3 ON/OFF COMPRESSOR A3 RELAYMLV ON/OFF MINIMUM LOAD VALVE RELAYSUB-MODE KEYPADENTRY ITEM DISPLAY ITEMEXPANSION COMMENTUNIT ENT AND LEAVE UNIT TEMPSCEWT XXX.X F COOLER ENTERING FLUIDCLWT XXX.X F COOLER LEAVING FLUIDCDET XXX.X F CONDENSER ENTERING FLUIDCDLT XXX.X F CONDENSER LEAVING FLUIDOAT XXX.X F OUTSIDE AIR TEMPERATURESPT XXX.X F SPACE TEMPERATUREDLWT XXX.X F LEAD/LAG LEAVING FLUIDENTERENTERENTER