Carrier Air Conditioner Owner's Manual

Also see for Air Conditioner: Operation and service guide Owner's guide

Contents

4SETTING THE TIME ON THE REMOTE CONTROL(Current Time Adjusting C and Reset Buttons) — Press cur-rent time adjusting button C to adjust the current time. Pressthe reset button with the tip of a pen or a paperclip if the re-mote control is not operating properly or after replacing thebatteries.1. With the remote con-trol ON or OFF,press C for at least5 seconds.2. The current hour flash-es. Press either orto set the currenthour. Press C againto move to set theminutes.3. Once the current timeis set, press C to con-firm it.FAN SPEED — To select the Fan mode and change the FanSpeed, follow the steps below:1. Press the Mode button to select the Fan mode.2. Press the Fan Speed button to select desired fan speed.NOTE: If unit is operating in Dehumidification mode the fanwill only operate in low speed and cannot be changed.TEMPERATURE SETTINGS — The temperature set pointcan be easily changed by pointing the controller toward the unitand pressing the increase/decrease temperature set pointbuttons until the desired temperature appears on screen.AIRFLOW DIRECTION — The louvers can be manuallyoperated by pressing the Louver button to change airflowdirection. Refer to Table 1 for louver positions.1. Operating mode (from left to right)Fan onlyHeating (heat pump models only)Automatic (heat pump models only)CoolingDehumidification2. Signal transmission symbol3. Temperature set point selected4. Address selected5. Temperature unit of measurement (°C or °F)6. Unit configuration7. Low Battery indicator8. Louver position9. Fan speed10. Turbo setting11. Economical setting12. ON timer selected13. Night timer active14. DAILY timer active (Everyday)15. ON timer and OFF timer or current time16. OFF timer selected17. Ionizer active1411210964253781117131615Fig. 4 — Remote Control Display Icons