Carrier CPCRKHTR002A00 Installation Instructions Manual

Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.PC 111 Catalog No. 534-754 Printed in U.S.A. Form 48GS,GX-3SI Pg 2 7-99 Replaces: 48GS-2SIBook 1 4Tab 1a 6aCopyright 1999 Carrier CorporationINSTALLATION1. Turn off gas supply, then main power supply to unit.2. Remove access panel for compressor and control box.See Fig. 1.3. Spread crankcase heater arms and slide crankcaseheater over the top of the compressor. See Fig. 1.4. Wrap heater around compressor base approximately2 in. above compressor mounting plate.5. Fasten heater firmly in place with fastening clip(Fig. 1) provided with the crankcase heater.6. Route crankcase heater leads into unit control box, fol-lowing the path of the compressor leads. See Fig. 1.7. Connect one black lead to the compressor contactorterminal 11, and connect other black lead to compres-sor contactor terminal 13 for 3-phase units; 23 (lineside) for single-phase units. See Fig. 2.8. Attach green crankcase heater ground lead to groundscrew in control box.9. Replace access panel.10. Turn on main power supply, then gas supply.C CH CBLK BLK11 13*CONTROL BOXCRANKCASEHEATERCOMPRESSOR INDOOR FAN MOTORROUTE WIRESAS SHOWNFig. 1 — Typical Crankcase Heater InstallationLEGEND*For 3-phase units only. For single-phase units, connect black leadto terminal 23 (line side)Fig. 2 — Crankcase Heater WiringC — Compressor ContactorCH — Crankcase HeaterMarked TerminalTOP CONDENSER SECTION NOT SHOWN

/ 2

Related manuals for Carrier CPCRKHTR002A00