Carrier Comfort 38MVC Series Owner's Manual

Contents

Carrier Comfort 38MVC Series Owner's Manual Manual pdf 6 page image

6REMOTE CONTROL FUNCTIONSPressing the On/Off Button ON/OFFIndicatorWhen the air conditioner is not in operation, the remote controlwill display the last set point and mode.S Press the On/Off button to start the unit.-- The unit will start in the last operating mode and setpoint. The ON/OFF indicator will appear.S Press button On/Off to stop the unit.-- All indicator lights on the unit will go out, and the remotecontrol will display the set point and mode.NOTE: If the On/Off button is pressed too soon after a stop, thecompressor will not start for 3 minutes due to the inherentprotection against frequent compressor cycling. The unit will onlyemit an audible beep when the signals are received correctly.Selecting an Operating ModeUse the Operating Mode button to select one of the availablemodes.AutoCoolDryHeatFanAUTO COOL DRY HEAT FANA07548Setting the Room Temperature Set PointPressing the increase temperature set point and decreasebuttons will raise or lower the temperature.The unit will confirm signal receipt with a beep and the value ofthe set temperature on the display will change accordingly.The temperature can be set between 62_F (17_C) and 84_F(29_C).NOTE: In Cooling mode, if the temperate selected is higher thanthe room temperature, the unit will not start. The same applies forthe Heating mode if the selected temperature is lower than theroom temperature.Selecting the Fan SpeedhighmediumlowThe fan speed can be selected by pressing the FAN SPEED button.NOTE: When fan is in AUTO mode, no speed will be displayed.NOTE: When the unit is on, the fan will run continuously incooling or heating. When in heating, there might be situationswhere the fan will slow down or shut off to prevent cold blow.Selecting the Horizontal Direction Louver PositionThe airflow direction can be adjusted to optimize air distribution.Press the AIR DIRECTION button repeatedly to choose one of thelouver positions.In the Cooling, Dehumidification, and Fan Only mode, the louverwill swing in the cooling range. In the Heating mode, the louverwill swing in the heating range.NOTE: Always use the remote control to adjust the louverposition, otherwise abnormal operation may occur. If the louver ismanually adjusted out of its range, turn the unit off and then onagain.Auto SwingTo have the louver moving continuously, push the SWING button.Push again to stop the louver.Selecting Vertical Direction of the LouverThe vertical louvers can be adjusted manually to direct the airflowto achieve the optimal comfort in the space.A07543Timer FunctionTIMER ON (to start the unit) and TIMER OFF (to stop the unit)can be used separately or together.Timer ON onlyTIMER ONThis function will allow the unit to start automatically after a setnumber of hours. The TIMER ON can be set while the unit is onor off.UNIT ON-- Press the TIMER ON button. “0:00” will be displayed. Everytime you push the button, the time increases by incrementsof .5 hours until 10 hours is reached. After 10 hours, theincreases are in increments of 1 hour.-- When the TIMER ON is set, the TIMER light on unitilluminates. The unit will shut off and it will start again afterthe set time elapses.UNIT OFF-- Set the timer described in the UNIT ON section.-- The unit will start when the set time elapses.