Carrier Debonair 33CS250-RC Installation, Start-up, And Operating Instructions Manual
Also see for Debonair 33CS250-RC: Owner's manual
        | |
Installation, Start-Up, andOperating InstructionsPart Number 33CS250-RCCONTENTS PageSAFETY CONSIDERATIONS . . . . . . . . . . . . . . . . . . . 1GENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-5Install Batteries . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1Select Transmitter Location (Optional) . . . . . . . . 1Mount Transmitter (Optional) . . . . . . . . . . . . . . . . . 2Set Clock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2Configure Advanced Set Up . . . . . . . . . . . . . . . . . . 2Program Thermostat Schedules . . . . . . . . . . . . . . . 3Calibration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5Check Thermostat Operation . . . . . . . . . . . . . . . . . 5Final Checklist . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5,6Auto-Changeover . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5Two-Stage Operation . . . . . . . . . . . . . . . . . . . . . . . . . 5Fan Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5Electric Heat . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5Keypad Lock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5Unit ID Number . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5Dry Contact Switch/External Control . . . . . . . . . . 6TROUBLESHOOTING . . . . . . . . . . . . . . . . . . . . . . . . . 6IMPORTANT: Read entire instructions before starting theinstallation. Leave installation instructions with owner af-ter performing installation.SAFETY CONSIDERATIONSRead and follow manufacturer instructions carefully. Fol-low all local electrical codes during installation. All wiringmust conform to local and national electrical codes. Im-proper wiring or installation may damage thermostat.Recognize safety information. This is the safety alert sym-bol . When the safety alert symbol is present on equip-ment or in the instruction manual, be alert to the potentialfor personal injury.Understand the signal words DANGER, WARNING, andCAUTION. These words are used with the safety alert sym-bol. DANGER identifies the most serious hazards which willresult in severe personal injury or death. WARNING signi-fies a hazard which could result in personal injury or death.CAUTION is used to identify unsafe practices which wouldresult in minor personal injury or property damage.GENERALThe wireless, 7-day, commercial, programmable ther-mostats maintain room temperature by controlling theoperation of an HVAC (heating, ventilation, and air condi-tioning) system. Separate heating and cooling set points andauto-changeover capability allow programming of 4 differ-ent time periods for energy savings.All thermostats allow up to 4 time/temperature settings tobe programmed per 24-hr period. Each thermostat stores pro-grams for 7 independent days. Batteries are required for op-eration. During power interruption (batteries removed) theinternal memory stores configuration and comfort schedulesfor an unlimited time. The clock will need to be reseteverytime power is lost (batteries changed).The wall mounted or hand-held transmitter sends its sig-nal to a receiver installed near the HVAC unit. Each trans-mitter and receiver can be given a separate house code formultiple thermostat applications. Up to 4 transmitters cansend information to one receiver device.The thermostat can be configured to accept severaldifferent equipment configurations, including heat pumpoperation.IMPORTANT: The transmitter and receiver are factory con-figured with a house code of 0. If more than one set ofwireless transmitters and receivers are used in the samelocation, the house codes must be different for the ther-mostats to communicate properly.INSTALLATIONInstall Batteries — Two AA lithium batteries are in-cluded with the transmitter. Remove the back cover and in-stall batteries. To ensure proper operation, only use AA lithiumbatteries as replacements.Select Transmitter Location (Optional) — Thetransmitter is wireless and no mounting or wiring of the trans-mitter is required. However, if a mounting location is de-sired for the transmitter, the transmitter should be mounted:• approximately 5 ft from the floor• close to or in a frequently used room, preferably on aninside partitioning wall• on a section of wall without pipes or ductwork• where temperature operating limits are within 41 to 104 F(5 to 40 C)• where humidity operating range is within 0 to 95% rela-tive humidity, non-condensingThe thermostat should NOT be mounted:• close to a window, on an outside wall, or next to a doorleading to the outside• where exposed to direct light and heat from a lamp, thesun, a fireplace, or any other temperature-radiating objectwhich may cause a false readingDebonair™Commercial Programmable ThermostatWireless TransmitterManufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.Book 1 4Tab 11a 13aPC 111 Catalog No. 533-322 Printed in U.S.A. Form 33CS-16SI Pg 1 11-98 Replaces: New |
Related manuals for Carrier Debonair 33CS250-RC
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine