LR03(AM4)1.5VLR03(AM4)1.5VRST TA6FLAP CONTROL BUTTONControls the discharge air flow direction up and down.( Refer to p.19 ) On start up, the flaps open automaticallyaccording to the operation mode.If you press this button, the flap will move stepwise andthe position will be displayed. If you press this buttonagain, the unit operates at “SWING” mode. At operatingmode “SWING”, the flap will swing up and downcontinuously.7ON/OFF TIMER AND CURRENT TIMEBUTTONSIf you set the ON and OFF times, the unit will automaticallyturn on and off at the set times.( Refer to pp.14 -15 )If you press the CLOCK button during Timer operation, youwill see the current time for 5 seconds.8 HOUR/MINUTE SETTING BUTTONSAdjust the current time (Refer Page 11) and the on/offtimes of timer operation, with these buttons.9RESERVATION AND CANCEL BUTTONSPress the RESERV. button to reserve the ON/OFF Timer andpress the CANCEL button to cancel the reservedon/off time. ( Refer to pp.14 -17 )10 EVERYDAY TIMER BUTTONPress the EVERYDAY button and the on/off time you havereserved will be repeated until cancelled. ( Refer to pp.14 -17 )11CURRENT TIME ADJUSTING BUTTONPress this button to adjust the current time.( Refer to p.11 )12RESET BUTTONPress this button when the remote control is not operatingproperly or after replacing batteries. ( Refer to p.11 )13ADDRESS SWITCHIf you have two indoor units in the same room, you canlink one remote control with one indoor unit, and link theother remote control with the other indoor unit.( Refer to p.11 )BEFORE OPERATIONOWNER S MANUAL - 95 FAN SPEED SELECTINGBUTTONPress the button to select the desired fanspeed of AUTO, LOW, MED or HIGH, andthe indoor fan will operate at theselected fan speed.If you select AUTO , the fan speed will becontrolled by the microcomputer of the unit.