NTC – My comfort controllerGB - 6Once the desired group of blinds is selected by the user (it mustflash), direct the remote control towards the unit and press button Dto raise the blinds of that group, or button F to lower the blinds.This operation is displayed as shown in fig. 11. Once back to thismenu, the last modified group of blinds flashes.Blind inclination (button B)By following the instructions above to select the desired group, it isalso possible, if enabled, to establish the blinds inclination. To doso, press button C until the blind reaches the desired inclination.This time, both arrows are flashing on the display:The different inclinations are shown onthe right.Selecting the fan speed(button E)The fan speed can be selected by pressing button .Indicated symbolLow speed(for night operation)Medium speedHigh speed(at start-up, to reach temperature)Automatic (fan speed will automatically switch to thevalue required for optimum comfort).If the unit is equipped with a variable speed motor, the selectablespeeds are 2: Auto and High.Energy savingThe Energy saving function is enabled if the remote control is notused for more than 30 minutes consecutively. All icons on thedisplay are switched off and the following configuration is set:If any key is pressed, the system goes back to the configurationshown in fig. 2 only if the lights have been set in the remote controlmenu. If not, the last configuration before activation of this functionis displayed.Use of the remote controlLights control (button B)If enabled, the following is the display visualization with system off(Unoccupied mode).If, during installation, several light groups are selected, theirnumber is displayed between the “1” and “A” icons which arealways present. The following figure shows an example where 3light groups are selected (a maximum of 4 groups is allowed).Press button B to start surfing inside the menu. The first group “1”starts flashing. Keep pressing button B until the desired group isselected (flashing). To switch on the lights of this group, direct theremote control towards the unit and press button C or D. To switchoff the lights, repeat the same operations but press button C or F.To operate all the lights select option “A”.The icon “on” or “off” flash for 3 seconds together with the selectedgroup to confirm switching on or off. After 3 seconds the message issent to the unit.Blinds control (button B)If enabled, select the menu before operating the blinds. Pressbutton B until the following configuration is displayed:If no button is pressed within 180 seconds the system quits themenu automatically. If several groups of blinds are selected, thegroup corresponding number is displayed between icon “1” and “A”which are always present.Press button B to surf within the menu.It follows an example of 2 selected groups of blinds.12345Fig. 131 AonoffFig. 6Fig. 10 Fig. 111 2 A 1 2 A1 AFig. 92 3 Aonoff1Fig. 71 3 Aonoff2Fig. 81 2 AFig. 12