5Emergency OperationBEFORE OPERATIONIoniser(Left) light : illuminated during Ioniser activated.Power(Right) light : illuminated during operation.Timer(Middle) light : illuminated during timer mode.EMER. buttonWhen the remote control is lost, damaged or the battery is discharged, the EMER. button can be used to run the unit.• Press the EMER. button once briefly at the off mode condition shorter than for 5 sec.- According to the room temperature, the unit operates the Cool mode in cool only model and the Auto modein Heat pump model.• If you want to stop the emergency operation, push the EMER. button again or operate the remote control.• The setting conditions of emergency operation are as follows:Indoor Unit Display• EMER. button :Can be used when the remotecontrol is lost or inoperative.EMER.buttonTest OperationThis operation is used for checking after unit installation.• Press the EMER. button continuously during 5~10sec. And then unit will beoperated as test mode.• Press the EMER. button once more after checking to activate the remotecontrol. If there is any input signal ( remote control signal or EMER. buttonpress ) during test operation, the TEST mode will change to the inputsignal mode.• The setting conditions of the test operation are as follows:- Operation mode : COOL - Fan speed : HIGH- Timer mode : Disable - Discharge air direction : SWINGCoolingonlyHeatPumpModel Operation Preset mode Fan speed Timer mode Discharge air directiontemperatureCOOL 24°C AUTO Disable HorizontalAUTO 25°C AUTO Disable Preset location accordingto ‘Cool’ or ‘Heat’ mode