|
– 144 –1 2 ENDOperation21SETTIMETIMER SETTESTFILTERRESETTEMP.CLFANSAVESWING/FIXVENTMODEON / OFFUNIT LOUVER1 2 3 END312SETTIMETIMER SETTESTFILTERRESETTEMP.CLFANSAVESWING/FIXVENTMODEON / OFFUNIT LOUVER11-5. Confirmation of Indoor Unit No. Position1. To know the indoor unit addresses though position of the indoor unit body is recognized• In case of individual operation (Wired remote controller : indoor unit = 1 : 1)(Follow to the procedure during operation)1 Push ON / OFF button if the unit stops.2 Push UNIT LOUVERbutton.Unit No. 1-1 is displayed on LCD.(It disappears after several seconds.)The displayed unit No. indicate line address andindoor unit address.(When other indoor units are connected to theidentical remote controller (Group control unit), otherunit numbers are also displayed every pushingUNIT LOUVER button.2. To know the position of indoor unit body by address• To confirm the unit No. in the group control(Follow to the procedure during operation) (in this procedure, the indoor units in group control stop.)The indoor unit numbers in the group control aresuccessively displayed, and fan, louver, and drain pumpof the corresponding indoor unit are turned on.(Follow to the procedure during operation)1 Push VENTand TESTbuttons simultaneously for 4seconds or more.• Unit No. is displayed.• Fans and louvers of all the indoor units in thegroup control operate.2 Every pushing UNIT LOUVER button, the unit numbersin the group control are successively displayed.• The unit No. displayed at the first time indicatesthe header unit address.• Fan and louver of the selected indoor unit onlyoperate.3 Push TESTbutton to finish the procedure.All the indoor units in the group control stop.
|
