5Part-1QUICK START OPERATIONPart-11. Initialization and Loading Memory Protection BatteryImportantYou must initializethe Cash registerand install thememory protectionbatteries before youcan program thecash register.w To initialize the cash register1. Set the Mode Switch to OFF.2. Plug the power cord of the cash register into an AC outlet.3. Load the memory protection batteries.4. Set the Mode Switch to REG.w To load the memory protection batteries1. Remove the printer cover.2. Press down on the oval just behind the printer paper inlet, and slide the batterycompartment cover toward the back of the cash register.3. Load 3 new UM-3, R6P (SUM-3) or LR6 (AM-3) type batteries into the compartment.Be sure that the plus (+) and minus (–) ends of each battery are facing in thedirections indicated by the illustrations inside the battery compartment (Figure 1).4. Slide the memory protection battery compartment cover back into place.5. Replace the printer paper and printer cover.REPLACE MEMORY PROTECTION BATTERIES AT LEAST ONCEEVERY YEAR.(Figure 1)2. To Select the Date Format and Monetary ModeYou can select the date format and Monetary mode after initialization depending on the requirements in your area.Default date format is Day/Month/Year.Default Monetary Mode is Add 2.Example:Change the date format to Month/Day/Year, and change Monetary modeto Add 3.1. Set the Mode Switch to PGM.2. Press the following keys.P3 appears in modedisplayProgram set code numberSelect numbers fromlists A and B(To end the setting)Date Format SelectionsAYear/Month/Day ?Month/Day/Year ZDay/Month/Year XMonetary Mode SelectionsBAdd 0 (0. ) ?Add 1 (0.0 ) ZAdd 2 (0.00 ) XsC o?ZXX oZC po