— 3 —2. MACHINE INTIALIZATION2-1. Initialization and loading memory protection batteryNote: You must initialize the cash register and install the memory protection batteries before you canprogram the cash register.To initialize the cash register1. Set the mode switch to OFF.2. Plug the power cord of the cash register into an AC outlet.3. Load the memory protection batteries.4. Set the mode switch to REG.To load the memory protection batteries1. Remove the printer cover.2. Open the battery compartment cover.3. Load 3 new UM-3, R6P (SUM-3) or LR6 (AM-3) type batteries into the compartment.Be sure that the plus (+) and minus (–) ends of each battery are facing in the directions indicated bythe illustrations inside the battery compartment.4. Slide the memory protection battery compartment cover back into place.5. Replace the printer paper and printer cover.REPLACE MEMORY PROTECTION BATTERIES AT LEAST ONCE EVERY YEAR.2-2. To select the date format and monetary mode (130CR only)You can select the date format and the monetary mode after initialization depending on the requirements in yourarea.Default date format is Day/Month/Year.Default Monetary Mode is Add 2.Example: Change the date format to Month/Day/Year, and the monetary mode to Add 0.1. Set the mode switch to PGM.2. Press the following keys.ADate format selectionsYear/Month/Day 0Month/Day/Year 13Day/Month/Year 2BMonetary mode selectionsAdd 0 (0. ) 0Add 1 (0.0 ) 1Add 2 (0.00 ) 2P3 appears in mode displaySUBTOTAL0 1 2 2 Program set code numberSUBTOTAL1 0 Select numbers fromlists A and B.(To end the setting)SUBTOTALCA AMT= TEND