10EPart-1 QUICK START OPERATION3. Loading Paper Roll And Replacing The Printer’s Ink RollMode Switch to REGOFFREGXZRFPGMCAL& Press the l key to take up anyslack in the paper.* Replace the printer cover by placingthe cover’s front tab into the regis-ter’s groove.2. To remove journal paper! Remove the printer cover followingthe instructions above.@ Press the l key until approxi-mately 20cm of the paper is fed fromthe printer.# Cut off the roll paper.$ Remove the take-up reel from theprinter and take off the left plate ofthe reel.% Remove the journal paper from thetake-up reel.^ Cut off the paper left in the printerand press the l key until theremaining paper is fed out from theprinter.1. To load journal paper! Remove the printer cover by liftingup the back.@ Put a roll of journal paper into theholder.# Cut the leading end of the roll paperwith scissors and insert the paperinto the inlet.$ Press the l key until 20 or 30 cmof paper is fed from the printer.% Roll the paper onto the take-up reela few turns.^ Set the left plate of the take-up reeland place the reel into the register.& Remove the core of the paper.* Load new paper following the in-structions above, and replace theprinter cover.◗ To replace the ink roll! Remove the printer cover.@ Lift up the tab on the ink roll marked“PULL UP”.# Install a new Ink Roll and press itdown firmly but gently until it snapsinto place.$ Replace the printer cover onto thecash register.% Press the n key to check forcorrect operation.Mode Switch to OFFOFFREGXZRFPGMCAL◗ To load receipt paper! To use the printer to print receipts,follow steps 1 through 4 of “To loadjournal paper”.@ Pass the leading end of the receiptpaper through the printer cover’s pa-per outlet and replace the printercover.# Tear off any excess paper.Default printer setting is for Journal.To print receipts, please refer to 1-7-3on page 24 to switch the printer forReceipt or Journal.Options: Roll paper – P-5860Ink Roll – IR-40