E-36Connection to a ComputerNAVIGATE CHANNEL (Default: 4)When messages are received from a computer for play onthis keyboard, the navigate channel is the channel whose notedata appears on the display. You can select one channel from01 to 16 as the navigate channel. Since this setting lets youuse the data on any channel of commercially available SMFdata to light on the on-screen keyboard guide, you cananalyze how different parts of an arrangement are played.1 Press the FUNCTION button until the NAVIGATECHANNEL screen appears.2 Use the [+], [–], and the number buttons [0] through[9] to change the channel number.Example: To specify channel 2To turn off specific sounds before playing back tune datathat is being received<>1 While playing tune data, press the RIGHT button.• This cuts the sound of the navigate channel, but on-screen keyboard guide keys continue to light inaccordance with the channel’s data as it is received.Press RIGHT button again to turn the channel backon.<>1 While playing tune data, press the LEFT button.• This cuts the sound of the channel whose number isone less than the navigate channel, but on-screenkeyboard guide keys continue to light in accordancewith the channel’s data as it is received. Press LEFTbutton again to turn the channel back on.Example: If the navigate channel is channel 4, the aboveoperation turns off channel 3.663A-E-038ASong Data StorageSong data saved as Song Bank tunes are retained even whenpower is turned off, as long as the keyboard is being suppliedbattery or AC adaptor power. If you remove the batteries orshould the batteries go dead while the keyboard is not beingsupplied power by the AC adaptor, song data will be deleted.Be sure to supply power to the keyboard with the AC adaptorwhen replacing batteries.NOTE• This keyboard supports SMF 0 and 1 format data.• Voice Fingering Guide and on-screen fingering indicatorsare not supported for commercially available SMF data.General MIDI ToneThe General MIDI standard defines the tone numberingsequence, the drum sound numbering sequence, the numberof MIDI channels that can be used, and other general factorsthat determine the sound source configuration. Because ofthis, musical data produced on a General MIDI sound sourcecan be played back using similar tones and identical nuancesas the original, even when played on another manufacturerssound source.This keyboard conforms with General MIDI standards, so itcan be connected to a computer and used to play back GeneralMIDI data that has been purchased, downloaded from theInternet, or obtained from any other source.Changing the SettingsThis section tells you how to make the settings required whenconnecting to a computer.KEYBOARD CHANNEL (Default: 1)The keyboard channel is the channel used to send messagesfrom this keyboard to a computer. You can specify one channelfrom 1 to 16 as the keyboard channel.1 Press the FUNCTION button until the KEYBOARDCHANNEL screen appears.2 Use the [+], [–], and the number buttons to changethe channel number.Example: To specify channel 4K e y b Cd hK e y b Cd hN a iv C. hN a iv C. h
