E-57MIDI*1 The BANK SELECT setting of PROGRAM CHANGE can be usedto access any of this keyboard’s 255 tones when selecting tones onthis keyboard from an external machine.Bank 0: 128 General MIDI tones (PROGRAM CHANGE 0 to 127)Bank 1: 118 panel tones (PROGRAM CHANGE 0 to 117)Bank 120: 9 drum sets(PROGRAM CHANGE 0, 8, 16, 24, 25, 32, 40, 48 and 62)Immediately prior to sending the PROGRAM CHANGE message,send two successive CONTROL CHANGE messages containingthe following data.CONTROL NUMBER= 0, CONTROL VALUE= CONTROL NUMBER= 32, CONTROL VALUE= 0Example: To select tone number 96 (panel tone “FLUTE 1”)from an external MIDI machine.CONTROL NUMBER= 0,CONTROL VALUE= 1 (bank number)CONTROL NUMBER= 32, CONTROL VALUE= 0PROGRAM CHANGE= 96*2 RPN stands for Registered Parameter Number, which is a specialcontrol change number used when combining multiple controlchanges. The parameter being controlled is selected using thecontrol values of control numbers 100 and 101, and then settingsare made using the control values of DATA ENTRY (controlnumbers 6 and 38).This keyboard uses RPN to control this keyboard’s pitch bend sense(pitch change width in accordance with bend data) from anotherexternal MIDI device, transpose (this keyboard’s overall tuningadjusted in halftone units), and tune (this keyboard’s overall finetuning).NOTE• Sustain (control number 64), sostenuto (control number66), and soft (control number 67) effects applied usingthe foot pedal are also applied.PROGRAM CHANGEThis is the tone selection message. PROGRAM CHANGE cancontain tone data within the range of 0 to 127.A PROGRAM CHANGE message is sent out through thiskeyboard’s MIDI OUT terminal whenever you manuallychange its tone number. Receipt of a PROGRAM CHANGEmessage from an external machine changes the tone settingof this keyboard.NOTE• This keyboard supports 128 tones in the range 0 to 127.However, Channel 10 is a percussion-only channel, andChannels 0, 8, 16, 24, 25, 32, 40, 48, and 62 correspondto the nine drum set sounds of this keyboard.PITCH BENDThis message carries pitch bend information for smoothlysliding the pitch upwards or downwards during keyboardplay. This keyboard does not send pitch bend data, but it canreceive such data.CONTROL CHANGEThis message adds effects such as vibrato and volume changesapplied during keyboard play. CONTROL CHANGE dataincludes a control number (to identify the effect type) and acontrol value (to specify the on/off status and depth of theeffect).The following is a list of data that can be send or receivedusing CONTROL CHANGE.Effect Control NumberBANK SELECT* 1 0, 32 Modulation 1 Volume 7 Pan 10 Expression 11Hold1 64Sostenuto 66Soft Pedal 67RPN* 2 100 / 101Data Entry 6 / 38 indicates receive-only messages642A-E-059ALK55_e_46_58.p65 03.2.17, 15:3257
