3• Automatic initializationUse the following procedure to initialize the cash register before using it for the first time after you purchase it.1. Install the two memory backup batteries (see page 10 of the User's Manual).2. Plug the cash register into a wall outlet.• At this time, “0000000000” appears on the display and the printer operates for a minite. Initialization is complete when the printer stopsoperating.CAUTION!Automatic initialization (which clears all sales and programming data stored in the register's memory) is performedwhenever all power (both the backup batteries and power through power cord) is cut from the cash register and thenrestored. The program data stored in the flash memory is restored.Remember…Main power cut by: Backup power cut off by: Automatic initialization when• Unplugging the cash register + • Removing the batteries = the main power is restored and• Power failure • Dead or low batteries the mode switch is set to anyposition besides OFF.• Manual initializationUse the following procedure to initialize the cash register and clear all transaction data and program data from its memory.1. Insert the mode key marked “PGM” into the mode switch.2. Turn the mode switch to the OFF position.3. While holding down the f (SE-C300) j (SE-C2000) key, turn the mode switch to the PGM position.4. Release the f (SE-C300) j (SE-C2000) key.5. Enter : : : : : ; and press the s key. *1), *2)C. Touch keyboardThis specification defines touchkeyboard with deparment orflat-PLU.Department keys are allocated2 72Flat PLU keys are allocated2 00A. Language selectionThis specification defines thelanguage to use for the date inreceipt/journal printing.English 2 0French 2 1Spanish 2 2German 2 4Clearing a machine lock upIf you make a mistake in opreation, the cash register may lock up to avoid damage to programs and preset data.Should it happens, you can use the following procedure to clear the lock up without losing any data.1. Power off the register.2. Insert the PGM key in the mode switch.3. Press down and hold f (SE-C300) f (SE-C2000), and turn the mode switch to PGM mode.4. The display shows INIT(SE-C300) / FC (SE-C2000) on alpha-display, then release f (SE-C300) f (SE-C2000).5. Press s. A receipt is issued.A B C D-Check Tracking System *2-w/o PGM 4 2 2with PGM 4 2 6D. System selectionand Program 4 modeThis specification definesSystem selection andProgram 4 mode availability.-Normal system *1-w/o PGM 4 2 0with PGM 4 2 4Initialization (SE-C300 / SE-C2000)B. Area / monetary modeThis specification defines thearea and the decimal position.German 2 4Two decimal place 2 1No decimal place 2 3*1) In case of Arabic character is used,enter ; : ; ; ; ; ; ; : : : : : ; and press the s key.*2) A,B,C,D: refer to the following.5 A B C D