16EGetting StartedX1Z1X2/Z2REG2REG1OFFRFPGMMode Switch3s8: : : : s8: :^: : : : a8: : : : a8: : : : a8: : : : a8: : : : a8: : : : a8: : : : a8s0125022503250425{ Tax table 1 =Tax table 2 =Tax table 3 =Tax table 4 =Tax rate (4-digit for integer + 4-digit for decimal)Tax table maximum value (“0” means unlimited).Rounding/tax table system code *1Sum of a cyclic patternNumber of values in each cyclic patternNumber of values in each non-cyclic pattern*1 Rounding/tax table system codeLoop to input the next block.Actual value of difference of the non-cyclic and cyclic valuesYou must enter these values in 4-digit block. If the last blockcomes out to be only two digits, add two zeros.D 1D 2D 3D 4D 3000D 4590Rounding code specificationTax system code specificationRoundingRounding off two decimal placesRounding up to two decimal placesCut off to two decimal placesD 11234D 20000RoundingTax table onlyU.S. tax table with tax rate or add-ontax rate onlyAdd-in tax rateCanadian tax system (Tax-on-tax)Canadian tax systemFor both add-on and add-in tax systems.To program Tax-on-tax system, you must use the tax address “0225”, “0325” or “0425.”(only for Canada)Programming procedureTax table programmingImportant!After you program the tax tables, you also have to individually specify which departments (page 36)and PLUs (page 39) are to be taxed.For this cash register to be able to automatically register state sales tax, you must programits tax tables with tax calculation data from the tax table for your state. There are three (U.S.)/four (Canada) tax tables that you can program for automatic calculation of separate salestaxes.10.
