Casio TE-M80 User Manual

Also see for TE-M80: Service manual Quick setup guide User manual

Casio TE-M80 User Manual Manual pdf 10 page image

10EPart-1 QUICK START OPERATION5 Remove the journal paper from thetake-up reel.6 Press the printer open key and openthe platen arm.7 Remove the core of the paper.8 Load new paper following the instruc-tions “1. To load journal paper”.4. Loading paper rollMode switch to REGCALREGOFFRFPGMXZREG1. To load journal paper1 Pressing down the printer open key.2 Open the platen arm.3 Ensuring the paper is being fed fromthe bottom of the roll, lower the rollinto the space behind the printer.4 Put the leading end of the paper overthe printer.5 Close the platen arm slowly until itlocks steadily.◗ To load receipt paper1 In case of defining the printer asreceipt printer, follow steps 1 through5 of “To load journal paper”.2 Pass the leading end of the receiptpaper through the paper outlet of theprinter cover.3 Tear off any excess paper.◗ To remove receipt paper1 In case of defining the printer asjournal printer, follow steps 6 through7 of “To remove a journal paper”.◗ Caution(in handling the thermal paper)1. Never touch the printer head and platen.2. Unpack the paper just before your use.3. Avoid heat/direct sunlight.4. Avoid dusty and humid places for storage.5. Do not scratch the paper.6. Do not keep the paper under the followingcircumstances: High humidity and tempera-ture/direct sunlight/contact with glue, thin-ner or a rubber eraser.Default printer definition is journal printer.To print receipts, please refer to 1-7-3 onpage 24 to switch the printer for receipt orjournal.Options: Roll paper ••• P-5880T6 Remove the printer cover by lifting upthe back.7 Roll the paper onto the take-up reel afew turns.8 Set the left plate of the take-up reeland place the reel into the register.9 Press the l key to take up anyslack in the paper.0 Replace the printer cover slowly.2. To remove journal paper1 Remove the printer cover by lifting upthe back.2 Press the l key until approximately20cm of the paper is fed from theprinter.3 Cut off the roll paper.4 Remove the take-up reel from theprinter and take off the left plate of thereel.platen armprinter cover