Controlling the Keyboard SoundsE-16Octave Shift lets you raise or lower the pitch of the keyboardnotes in octave units.• The octave shift setting range is –2 to +2 octaves.• When using Split (page E-13), you can individually set theleft and right keyboard ranges to the pitches you want.1. Keep pressing cq until the screen shown belowappears on the display.If you want to use Split, turn on Split before pressing cq.• If you do not perform any operation for a few secondsafter this screen appears, the display will return to theprevious screen automatically.2. Use the bs (10-key) [–] and [+] keys to shift theoctave.3. Press cq.4. Press cq again.You can use the pitch bend wheel to slide the pitch of notessmoothly upwards and downwards. This technique makes itpossible to produce effects that are similar to soundsproduced when bending notes on a saxophone or electricguitar.1. While playing a note on thekeyboard, rotate the pitch bendwheel on the left of the keyboardupwards or downwards.The amount the note bends depends on howmuch you rotate the pitch bend wheel.• Do not have the pitch bend wheel rotatedas you turn on the Digital Keyboard.Use the following procedure to specify how much the pitch ofthe note changes whenever the pitch bend wheel is rotatedupwards or downwards. You can specify a range from 0 to 12semitones (one octave).1. Press ct and then use the bs (10-key) [4] ( )and [6] ( ) keys to display “OTHER” (pageE-6).2. Press bs (10-key) [7] (ENTER) key.3. Use the bs (10-key) [4] ( ) and [6] ( ) keysto display “Bend Rng”.4. Use the bs (10-key) [–] and [+] keys to changethe range.Octave Shift• Split On : This step affects the right side keyboardrange only.• Split Off : This step affects the entire keyboard range.• Split On : The screen shown below will appear. Use thebs (10-key) [–] and [+] keys to shift theoctave for the left side keyboard range.• Split Off : The screen shown below will appear.Advance to step 4.O c t U p p e rO c t L o w e rUsing the Pitch Bend Wheel toShift the Pitch of Notes(WK-500 Only)To play with the pitch bend wheelSpecifying the Pitch Bend RangeO T H E RFlashesB e n d R n gWK200_02_e.fm 16 ページ 2008年5月19日 月曜日 午後7時14分