Cateye CC-VL500 User Manual
Also see for CC-VL500: Quick start guideUser manual
Contents |
Caution• Do not concentrate on the computer operations while riding. Always be sure to ride safety.• Be sure to securely mount the magnet, sensor and bracket on your bicycle, and periodically check to see if anyparts have loosened.• Used batteries are harmful if swallowed by mistake. They must be disposed in accordance with local regulations.• Do not leave the main unit exposed to direct sunlight. Never disassemble the main unit.• For cleaning of the main unit or accessories, use diluted neutral detergent on a soft cloth, and then wipe it off witha dry cloth. Do not use paint thinner, benzine or alcohol since such chemicals may damage the surface.Package Contents1 Bracket2 Wire3 Sensor4 Magnet5 Nylon Ties 7IMPORTANT!Correct positions of the sensor and the magnet:A When rotating the front wheel, the magnet's 4 center must be aligned with the sensor's 3 marking line.B The distance between the sensor 3 and the magnet 4 must be less than 5mm.Name of PartsSpeed 0.0 (4.0) to 299.9 km/h [0.0 (3.0) to 185.0 mph]Mode Symbol Indicates the mode currently selected.(The corresponding value is indicated on the lower line.)Pace Arrow* Indicates if the current speed is faster or slower than the average speed.( Faster Slower)Speed ScaleSub Display (selected function)Battery Case CoverContact*The Pace Arrow feature is only available on the VELO8. Pace Arrows are not displayed on the VELO5.Display function• Tm* [Elapsed Time] 0:00'00" to 9:59'59"• Dst [Trip Distance] 0.00 to 999.99 km [mile]• Av* [Average Speed] 0.0 to 299.9 km/h [ 0.0 to 185.0 mph](Measurable up to 27 hrs or 999.99 km/h)• Mx [Maximum Speed] 0.0 (4.0) to 299.9 km/h [0.0(3.0) to 185.0 mph]• Cal* [Calorie Consumption] 0.0 to 9999.9 kcal (estimated from speed data)• Odo [Total Distance] 0.0 to 9999.9 km [mile]• [Clock] 0:00' to 23:59'[1:00'to 12:59']* This feature is only available on the VELO8. No measurement is done on the VELO5.Start/Stop of MeasuringThe unit starts measuring automatically when you start pedaling, and stops measuring when your come to a stop.The upper display always shows the Current Speed.Shift of Lower DisplayEach time you press the MODE button, a different data value appears on the lower line. ePower Saving FunctionIf the main unit does not receive a signal after about 10 minutes, the main unit enters Power Saving Mode anddisplays the clock count only. To re turn to normal display, press the MODE button or start your bicycle again tocancel the Power Saving function.Data ResetWhen a screen with the Reset mark in the OPERATION FLOW is displayed, continue pressing the MODE buttonand the measured data will return to zero. However, the Odometer (total distance) and Clock do not return to zero.How to Set ClockIn the clock mode, press SET button on the back, and the display enters clock setting mode.*If Km/h has been selected for speed scale, it becomes 24-hour clock.If mph has been selected, it becomes 12-hour clock. fHow to Change Tire SizeDisplay the Total Distance (Odo) and press the SET button to change the tire size. You can select a tire size in twoways: Either select from among preset sizes c or enter the tire’s circumference directly in increments of 1 cm. dMaintenance• If the contact of the unit or the bracket gets wet, dry it off with a cloth. If they become rusty, it will cause speeddetection error.• If the gaps between the buttons and the unit get clogged with mud or sand, wash them away with water.TroubleshootingNo display.Has the battery in the main unit run down?Replace it with a new one.Incorrect data appears.Do all clear operation.Current speed does not appear.(First, short-circuit the contact of the main unit a few times with a piece of metal. If currentspeed appears, the main unit is working fine and the cause should be attributed to the bracket or the sensor.)Is the clearance between the sensor and the magnet too large?Are the magnet's center and the sensor's marking line aligned?Re-adjust the positions of the magnet and the sensor. (The clearance should be less than 5mm.)Is the cord broken?Even if the outside of the cord looks normal, there could be damage.Replace the bracket and sensor set with a new one.Is there anything sticking on the contact of the main unit or the bracket?Clean the contact with a cloth.Current speed disappears when using in the rain.Wipe any water or dirt from the contacts and apply a water repellent silicon grease. Do not apply standard grease,as it may cause damage to the bracket.Replacing BatteryIf the screen becomes dim, it is the time to replace the battery. g*Insert a new lithium battery (CR2032) with the (+) mark facing up.1 After replacing the battery, perform the all-clear operation. Follow SETTING to select the measurement unit & tiresize and set the clock display to the current time.SpecificationBattery ---------------------- Lithium Battery CR2032 x 1(battery life: approx. 3 years)(*The life of the factory-loaded battery might be shorter than this.)Microcomputer ------------- 4-bit 1-chip (Crystal controlled oscillator)Display ---------------------- Liquid crystal displaySensor ---------------------- No-contact magnetic sensorTire Sizes ------------------- Tire sizes of 16, 18, 20, 22, 24, 26, 700C, and 27 inches, or tire peripheral lengths from 100 to 299cm (Initial value: 26 in.)Working Temperature ------ 0°C - 40°CLength of Wire ------------- 70cmDimension/Weight --------- 1-7/8" x 1-25/32" x 23/32" (48 x 45 x 18 mm) / 1.06 oz ( 30 g)*The specifications and design are subject to change without notice.CATEYE VELO 8VELO 8CATEYE VELO 5VELO 5MODESET(on Back)FGCAT EYE VELO 5CAT EYE VELO 8CYCLOCOMPUTERModel CC-VL500/CC-VL800EnglishU.S. Pat. Nos. 4642606, 5236759 and Pat. PendingCopyright© 2003 CAT EYE Co., Ltd.CCVL5/8-031030 066600280 1®CATEYE VELO 53INSTALLING THE UNIT236 A B433635415mm511 2 34SETTING56 7●Calorie Consumption *1(VELO8)The calorie consumption data is only the accumulated value that iscalculated from the speed data of every second. It differs from theactual consumed calorie.km/hSpeed 10 km/h 20 km/h 30 km/hKcal per hour 67.3 kcal 244.5 kcal 641.6 kcalmphSpeed 10 mph 20 mph 30 mphKcal per hour 155.2 kcal 768.2 kcal 2297.2 kcalClick |
Related manuals for Cateye CC-VL500
manualsdatabase
Your AI-powered manual search engine