Catrike TRAIL Owner's Manual
Also see for 2007 Road: Owner's manualOwner's manual
                                                                | |
OWNER’S MANUAL PAGE 18Install front wheelsAttach the front wheels to their respective spindle/steering arm assemblies. First,identify the left and right wheels and set them on the correct side of the trike. Unscrewthe quick release to remove domed axle nuts for wheel installation.Now you can place the wheel in position, sliding the disc in between the brake pads.Place the wheel hub opening directly over the axle, then slide the axle through the hubfrom behind the spindle assembly. The quick release lever goes on the inside of thespindle. The bolt and its retaining ring go on wheel. Place the cone-shaped retainingring (flat side in) against the hub, thread the quick release bolt in and hand-tighten it.Then close the quick release lever for a tight hold.These quick releases hold the wheels on, so, it’s very importantthat they be kept secure. Check them from time to time.Handlebar adjustmentYour new Catrike adjustable handlebars can be adjusted in many ways to give eachCatrike owner a custom fit. The long, horizontal portion of the handlebar has a gentleincline to it. For those riders who prefer lower handlebars, this can be installed upsidedown to provide a gentle downward slope. The same holds true for the shorter gripportion of the handlebar. It has a gentle angle leaning forward but can be reversed. Youcan see the difference in mounting in the pictures below. The picture on the top showsthe recommended standard setup.The handlebar sets come in left and right sides. When mounting them upside down,simply swap sides to keep the heads of the screws on theinside of the trike, making them easier to reach with theAllen key.Domed axle nut onOutside when installedQuick Release on Insidewhen installed on trikeClick HERE or scan QRcode below to video aids. |
Related manuals for Catrike 2007 Road
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine