9TROUBLESHOOTINGCheck the following points before calling your local authorised Service Centre.PROBLEMS CAUSE SOLUTIONThe filter is blocked.The temperature or humidityin the room are too low.The room is too big for thedehumidifying power of theappliance.Too many sources of humidityin the room (pots of boilingwater, etc.).The humidy set point is toohigh.Clean the filter.In certain conditions, it is nor-mal for the appliance not todehumidify (in certain cases,it is recommended to heat theenvironment).Decrease the humidity setpoint.The safety device has tripped. Wait for 3 minutes to pass.The tank is missing.The tank is full.The tank is incorrectlypositioned.The temperature in the room isvery low.One of the sensors on theappliance is faulty.The pump tube 9 is missing orclogged or blocked.Replace the tank.Empty the tank.Position the tank correctly.Increase room temperature.Call the Service Centre.Check the hose is correctlypositioned or unclogged, Toreset the alarm disconnect andreconnect the plug. If the pro-blem persists, call the servicecentreThe appliance is operating indehumidifying mode, but thehumidity does not decrease.The appliance does notwork for 3 minutes afterstart-up.is displayedis displayed“E2”/”E3” is displayedSymbol “PUMP/POMPE”blinkingGB