2016.9 Cleaning the infuserThe infuser (A19) must be cleaned at least once a month.Important!The infuser may not be extracted when the machine is on.1. Make sure the machine is correctly turned off (see section“7. Turning off”);2. Remove the water tank (A16) (fig. 3);37 38PUSHPUSH3. Open the infuser door (A18) (fig. 37) on the right side ofthe appliance;4. Press the two coloured release buttons inwards and at thesame time pull the infuser outwards (fig. 38);5. Soak the infuser in water for about 5 minutes, then rinseunder the tap;Important!RINSE WITH WATER ONLYNO WASHING UP LIQUID - NO DISH WASHERClean the infuser without using washing up liquid as itcould be damaged.6. Use the brush (C5) to remove any coffee residues left in theinfuser housing, visible through the infuser door;7. After cleaning, replace the infuser by sliding it onto theinternal support (fig. 39), then push the PUSH symbol fullyin until it clicks into place;39 40Please note!If the infuser is difficult to insert, before insertion, adapt it to theright size by pressing the two levers shown in fig. 40.41PUSH8. Once inserted, make surethe two coloured but-tons have snapped out(fig. 41);9. Close the infuser door;10. Put the water tank back.16.10 Cleaning the milk containerTo keep the frother efficient, clean the milk container (D) everytwo days as described below:1. Remove the lid (D2);2. Remove the milk spout (D5) and intake tube (D4) (fig. 42);3. Turn the froth adjustment dial (D1) anticlockwise to the“INSERT” position (fig. 42) and pull it off upwards;424. Wash all the components thoroughly with hot water andmild washing-up liquid. All components are dishwashersafe, placing them in the top basket of the dishwasher.Make sure there are no milk residues on the hollow andgroove under the dial (fig. 43). If necessary, scrape thegroove with a toothpick;