Dürkopp Adler 767 Installation Instructions Manual

Also see for 767 -: Instructions Instructions Instructions Operating instructions

Contents

2. Setting upIMPORTANT !The special sewing machine may only be set up by trainedspecialist personnel.Packing must be removed prior to setting-up.– Remove safety bands and wood from upper part, table and frame.– Remove safety bands and block from motor.2.1 Erecting the upper partIf the special sewing machine was not delivered fully assembled:– Screw hinges 2 and 3 to base plate.Attach upper-part support 1.– Fit upper part.– Fit and tension V-belt (see section 2.3).– Fit belt guard and oil bath.– Align surge container 9.The surge container must be turned so that it is vertical when the upper part of themachine is vertical.– Place oil-recirculation felt 7 in the depression of the oil bath.The hose 8 must not make contact with moving parts.2.2 TransportFor internal transport the sewing machine must be lifted and moved by a suitablevehicle (e.g. a fork-lift).2.3 V-belt tensionAfter the machine has been moved the pre-set V-belt tension must be checked.The tension in the V-belt 6 must be such that it can be depressed by about 10 mm byapplying finger pressure in the middle.– Loosen nuts 4 and 5.– Swivel drive until V-belt tension is correct.– Retighten nuts 4 and 5.GB5