DAITEM 145-21X Installation Manual

Contents

DAITEM 145-21X Installation Manual Manual pdf 13 page image

GB781. Put DIP switch 1 in the ONposition.2. Close the detector cover.3. Switch the control panel totest mode:4. Check the area of detectionusing the indicator LED andadjust the detector if need be.With each detection thecontrol panel issues the voicemessage “Beep, deterrencedetector X” (depending on theconfiguration).5. Switch the control panel backto installation mode, press:6. Reopen the cover, to put DIPswitch 1 to OFF.Close the detector cover andtighten the locking screw.8. Operating test8.1 Detection zone test1. Switch the control panel touser mode:2. Put your control panel in TotalArm mode.3. Wait for the exit time delay.4. Cross over the protected areaand check that the controlpanel responds (see yourcontrol panel’s installationmanual).8.2 Real testThe control panel takes batteryfaults, anti-tamper faults andradio faults on the detector intoaccount.Battery faultFollowing a system command,the control panel issues thefollowing voice message: “beep,fault, battery, detector X” .Anti-tamper faultFollowing a system command,the control panel issues thefollowing voice message: “beep,fault, anti-tamper, detector X” .Radio faultFollowing a system command,the control panel issues thefollowing voice message: “beep,fault, radio, detector X” .9. Maintenance9.1 Fault indication1. Switch the control panel toinstallation mode and ask themaster user to press:then press:2. Open the case of the detector(see § Opening the detector).3. Replace the used lithiumbatery.9.2 Changing the batteryIMPORTANT: the detector’sconfiguration is saved when thebattery is changed.IMPORTANT: the test button makes it possible to chec k if the batteryis OK. The indicator on the radio board lights red when the buttonis pressed.master codeengineerinstaller codeengineerinstaller codeengineerinstaller codeengineerinstaller code