DFX-7 Ultrasonic Thickness Gauge27COATING 2PT: Performs a two-point coating calibration. This option allows theuser to automatically calculate the velocity by entering a second known coatingsample thickness. Refer to page 103 for further info.COATING VEL: Function to calibrate the DFX-7 to a specific coating material typeby entering a coating velocity. Refer to page 16 or page 97 for further info.3.4 DISP (display) – MenuVIEW: Selectable ASCAN (waveform), BSCAN (cross section), and DIGITS (largedigits) views. Refer to page 60 for further info.DELAY (B-START): Provides the user the ability to change the start position of theA/B SCAN views. Refer to page 68 for further info.RANGE (B-DEPTH): Provides the user the ability to change the overall depth of theviewable measurement area. It functions a lot like a zoom on a camera. Refer topage 70 for further info.B-SCAN SPEED: Controls the speed of the time based B-Scan with an arbitraryscale of 0-10, with 10 being the fastest scrolling speed. Default speed set at 6.Refer to page 72 for further info.UNITS: Toggle between English or Metric units. The readout will change frominches to millimeters.BRIGHTNESS: AMOLED high speed color display. An arbitrary scale of 1-20 hasbeen implemented, with the brightest setting at 20. Refer to page 108 for further info.COLORS: Provides the user with 12 different color schemes to select from. Thereare two schemes for each main color option. Refer to page 109 for further info.LANDSCAPE: Displays the A-Scan waveform in landscape view for a largerviewable area, with either right or left hand option. Refer to page 109 for further info.DIM: Allows the user to conserve battery life by diming the display after idle for aspecific amount of time – OFF, 30, 60, 90, 120 seconds. Once dimmed, a singlepress of any key will restore the screen brightness. Refer to page 111 for further info.RECT WAVE: This option provides the user an outlined or filled view option whenthe display setting is in RECT (rectified) wave mode only. Refer to page 68 forfurther info.DETECT MARK: Selectable graphics option for the point of detection on thewaveform: Line, Box, Dots, None. Offers the user a graphics preference on howthey prefer to view the detection on the waveform. Refer to page 113 for further info.