DAPAudio Core Kontrol D2 Manual

DAPAudio Core Kontrol D2 Manual Manual pdf 12 page image

11Ordercode: D1261Core Kontrol D2Mixer Functions33) Track select encoderDepending on the browser panel (see page 22) you are in, you can use the encoder to select acertain track or folder. Confirm your choice by pressing the encoder.34) Load A buttonPushing this button loads the selected track in deck A and activates the cue function for channel 1.The cue 1 (39) button will light up.35) Channel 1 gainThe gain control allows you to adjust the input-sensitivity for a channel and thus optimally match theincoming signals to the mixer’s internal operation level.36/37/38) Channel 1 equalizer section (HI / MID / LOW)Use the 3-band equalizer to adjust tone for each channel by using the Hi, Mid and Low controls. Pusha control to kill (mute) the corresponding band.39) Cue 1 buttonTapping this button will allow the audio from that channel to be cued in the headphones. Selectingcue 1 will deselect cue 2. Please ensure that headphones volume (55) is not completely turneddown.40) Channel 1 faderThe fader controls the volume of the corresponding channel.41) X-Fader slope switchAllows you to select the response (cut/linear) of the cross fader.42) Cross faderThe crossfader allows you to mix smoothly from one source to another (only whenboth faders are up).43) Load B buttonPushing this button loads the selected track in deck B.44) Back buttonThis button in combination with the track select (33) encoder allows you to navigate through thebrowser panels. See page 13: “01) Selecting folders” and “02) Selecting tracks”45) Channel 2 gainThe gain control allows you to adjust the input-sensitivity for a channel and thus optimally match theincoming signals to the mixer’s internal operation level.46/48/50) Channel 2 equalizer section (HI / MID / LOW)Use the 3 band equalizer to adjust the tone for each channel by using the Hi, Mid and Low controls.Push a control to kill (mute) the corresponding band.47) Master LevelUse to adjust the volume level of the master RCA (60) or the master XLR (61) outputs.Note: This is an analog control and does not send MIDI commands.49) Cue mix controlAllows the user to hear mixed audio of the monitor (cue) audio and the program (master) audio inthe headphones. When the control is rotated to the left only the cue audio will be heard, whenrotated to the right, only the program audio will be heard.Note: This is an analog control and although it does send MIDI commands, this control is notrepresented in the Virtual DJ LE software GUI.51) Cue 2 buttonThis button will allow the audio from that channel to be cued to the headphones. Please ensure thatheadphones volume (55) control is not turned down completely.52) Channel 2 faderThe fader controls the volume of the corresponding channel.