DAPAudio D2680 Product Manual

Contents

DAPAudio D2680 Product Manual Manual pdf 9 page image

723. AC Inlet With Integrated Fuse HolderThis connector is meant for the connection of the supplied main cord. Connect one end of thepower cord to the connector, the other end to the mains, then turn on the Power Switch (11) tooperate the unit.Note: Please make sure that the supply voltage matches the operation voltage before connectingthe unit to mains.Replace the fuse only with a fuse of same specification (230V:T6.3A/ 115V: 12A).OperationInstallationRemove all packing materials from the 8 Zones Multiroom System. Check that all foam and plasticpadding is removed.Secure the equipment into a 19" rack. Connect all cables.Connecting Power / Circuit Size Requirements.The actual current draw, the amplifier demands from the AC mains, depends on many factors (its load,output level or the crest factor of its program material).The power requirement is rated under typical music conditions, with both channels driven so those peaksare just at the clipping point.Make sure the mains voltage is correct and is the same as printed on the rear of the amplifier. Damagecaused by connecting the amplifier to improper AC voltage is not covered by any warranty. Unlessotherwise specified when ordered. DAP audio amplifiers shipped to customers are configured as follows:North America 120VAC/60HzEurope 230VAC/50HzAsia 220VAC /50Hz/60HzAustralia 240VAC/50HzSouth America 120VAC/60Hz or 220VAC/50HzJapan 100VAC/50HzNOTE: Always turn off and disconnect the amplifier from mains voltage before making audio connections.Also, as an extra precaution, have the attenuators turned down during power-up.Dip switch settingsDIP switch on the back can be used has 3 functions:1. Use DIP switch 1-5 to assign an address to each device if using multiple devices together.Fig. 3