DAPAudio DCP-26 Manual
Also see for DCP-26: Manual
                                    | |
Contents
| 
12DCP-26Productcode: D2084Output setupSelect output 1 by pushing the Channel Up (3) button or the Channel Down (4) button. If you are onlyable to select Out 12, Out 34 and Out 56, all 6 channels are linked (in pairs). If you want to adjust all 6output channels separately, you’ll have to unlink the channels (see page 12).Adjust the gain by dialling the jogwheel (8). Pushing the item Up (2) button allows you to proceed withthe next item, in our example the mixer.Adjust the mix volume for input A by dialling the jogwheel (8). Pushing the item Up (2) button allows youto proceed with the mixer menu. Note: the mixer menu is only enabled if the input channels are notlinked.Adjust the mix volume for input B by dialling the jogwheel (8). Push the item Up (2) button to proceedwith the Delay setup.Click the jogwheel (8) to adjust the “delay” in mm, inch or ms. Then adjust the delay time by dialling thejogwheel (8). Push the item Up (2) button to proceed with the Low Pass filter menu.Out 1 gain-1.25dbOut 1 mixer:Input A: odbOut 1 mixer:Input b: offOut 1 delay0mmOut 1 lowPassFreq: off |
Related manuals for DAPAudio DCP-26
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine